FPN941E
Part of Flotrex™ PN Pleated Filters with Polypropylene Microfiber Media
The Flotrex PN (FPN) microfiber filters (Figure 1) offer an economical solution for your filtration needs.
Literature
Specifications
- Effective Filtration Area
- 6 ft² / 1 m²
- End #1 Adapter
- 222 O-Ring
- Filter Model
- FPN94
- Nominal Cartridge Length
- 25 cm / 10 in
- Nominal Micron Rating
- 0.45 µm
Note
Trademark of General Electric Company; may be registered in one or more countries
Typical Applications
FPN filters are an economical alternative to membrane filters in a broad range of applications, Including:
- Filtration of liquid polymers, coatings, and inks
- Filtration of bulk chemicals
- Beer trap filtration
- Post Carbon bed and DI bed filtration
- Pre-filtration to protect expensive final filters
General Properties
Flotrex PN filters are available in the following nominal pore size micron rating: 0.2, 0.45, 1, 2, 3, 5, 10 and 30 µm. Tables 1, 2, 3 and 4 show further details on materials of construction, dimensions, operational limits and flow performance.
Additional Information
- Flotrex PN filters may be autoclaved or in situ steam sterilized (up to 257°F [125°C], 30-minute cycles) for a maximum accumulated exposure of 10 hours. Alternately, the filters may be sanitized with compatible chemical agents.
- GE certifies that the material contained in its Flotrex PN pleated filters meet U.S. FDA requirements for food contact under the applicable regulations in 21 CFR. For further information, contact GE technical services. Flotrex PN filters meet the test criteria for USP class VI- 121°C Plastics.
- Aqueous extracts from Flotrex PN filters contain less that 0.25 EU/ml. The filters typically exhibit low levels of non-volatile residues.
- GE filter cartridges are designed and manufactured for resistance to a wide range of chemical solutions. Conditions will vary with each application and users should carefully verify chemical compatibility. Please contact your GE distributor for more information.
Line Specifications
- Core and Cage
- Polypropylene
- Elastomer Material
- Buna-N, EPDM, PTFE, Silicone, Viton
- End #2 Adapter
- 120 O-Ring, 213 O-Ring, Closed End Cap, Fin Adapter, Open End Gasket
- Endcaps and Adapters
- Polypropylene
- Filtration Media
- Polypropylene Microfiber
- Maximum Forward Differential Pressure @ 70°F (21°C)
- 4.1 bar / 60 psi
- Maximum Operating Temperature at 10 psid (0.69 bar) in Water
- 82 °C / 180 °F
- Maximum Reverse Differential Pressure @ 70°F (21°C)
- 2.1 bar / 30 psi
- Nominal Inside Diameter
- 1.25 in / 31 mm
- Nominal Outside Diameter
- 2.75 in / 70 mm
- Support Layers
- Polypropylene Microfiber
- Type
- FPN
See more parts in Flotrex™ PN Pleated Filters with Polypropylene Microfiber Media
Request a Quote
This part number is already on the request. Tell us how many you need and our specialists will come back to you.